Elephant foot - change up the flow on the first layer if that is the only layer giving you trouble and don't let it extrude as much, slicers usually have you extrude more here to help it stick.Bed Level Correction - I have this in the Prusa machine and I used it to try to fix the corner that wasn't working as well.First Layer Calibration - make sure it isn't too close, you may have to just change the settings up when you do puzzle prints.4mm (2 layers) and work your way up in thickness as you are dialing it in in certain areas. If you are doing a lot of tests, you can start with just. 1mm is good as I feel the base of your puzzle should be at least that thick to get a sturdy but not too thick puzzle. I recommend that you print the test at at least 1mm thick, but you can go up to a few millimeters depending on how thick your prints will be. 15mm to work, but if not, you have backup options and the pieces will just fit a little looser together. I took the time to create a simple design that has puzzle line thicknesses ranging from.
0 Comments
Leave a Reply. |